Transition Networks SBFTF1015-120 Set the Dip Switches -- Continued, Fiber Mode Fiber Port

SBFTF10xx-12x

Installation -- Continued

Set the Dip Switches -- Continued

NOTE: Dip switch 4 (in the “SW” set) applies to fiber port 1 (F1).

Installation -- Continued

Set the Dip Switches -- Continued

NOTE: Dip switches 1, 2, 3, and 4 (in the Config. Switches set) apply ONLY to twisted-pair copper port 2 (TP2).

4. Fiber Mode (Fiber Port 1)

Up (Full-Duplex)- The cable distances for fiber port 1 (F1) are constrained by the cable requirements (see pages 1 and 2).

Down (Half-Duplex)- The cable distances for fiber port 1 (F1) are constrained by the 512-Bit Rule (see page 9).

4

UP

Fiber Full-Duplex

DOWN

Fiber Half-Duplex

1. Twisted-Pair Auto-Negotiation		1
Up (Enabled) - The media converter “advertises”
ALL rate and mode capabilities to the network:		UP
• 100Mb/s full-duplex	• 100Mb/s half-duplex,	Twisted-Pair Auto-Negotiation ON
• 10Mb/s full-duplex	• 10Mb/s half-duplex.

Down (Disabled) - The bridging media converter DOWN

NOTE: DIP switch 5 (in the “SW” set) applies to ALL twisted-pair copper ports (TP1, TP2, TP3, TP4, TP5).

does not “advertise” the rate and mode Twisted-PairAuto-Negotiation OFF capabilities to the network. Switch 2 and switch 3

are then used to set the twisted-pair rate and mode.

5. AutoCross

Up (Enable) - The media converter connects automatically to either straight-through or crossover twisted-pair copper cable.

Down (Disable) - Either straight-through or crossover twisted-pair copper cable must be installed, according to the site requirements

5

UP

AutoCross Enable

DOWN

AutoCross Disable

2. Twisted-Pair Rate

Up (100Base-TX)- Sets the twisted-pair rate to 100Base-TX.

Down (10Base-T)- Sets the twisted-pair rate to 10Base-T.

2

UP

Twisted-Pair 100Base-TX

DOWN

Twisted-Pair 10Base-T

6. Not in use

3. Twisted-Pair Mode

Up (Full-Duplex)- The twisted-pair cable distances are constrained by the cable requirements (see pages 1 and 2).

Down (Half-Duplex)- The twisted-pair cable distances are constrained by the 512-Bit Rule (see page 9).

4. Monitor for Twisted-Pair Port 2 (TP2)

Up (Off) - The twisted-pair port 2 (TP2) functions as directed by switches 1, 2, and 3.

Down (On) - The twisted-pair port 2 (TP2) functions as a “sniffer” port and transmits all packets received from ports F1 and TP1.

3

UP

Twisted-Pair Full-Duplex

DOWN

Twisted-Pair Half-Duplex

4

UP

Monitor on TP2 OFF

DOWN

Monitor on TP2 ON

4 24-hour Technical Support: 1-800-260-1312-- International: 00-1-952-941-7600 techsupport@transition.com -- Click the “Transition Now” link for a live Web chat. 5