Transition Networks |
DIN rail mounting
DIN rail clip | The Industrial Switch includes an aluminum DIN Rail Clip attached to the rear panel. Verify |
| the clip is attached and oriented as pictured in Figure 4 below. |
DIN Rail Clip (installed)
Metal spring
Screws (3)
Figure 4: Mounted DIN Rail Clip
DIN rail mounting Consider the following before mounting the DIN rail to a surface and attaching the Industrial
considerations Switch:
•The surface must support at least 635g (1.4 lbs) for the Industrial Switch.
•Do not place heavy objects on the Industrial Switch.
CAUTION
Mount the Industrial Switch with proper spacing around it for ventilation (heat dissipation). Failure to observe this caution could result in damage to the Industrial Switch.
CAUTION
Please exercise caution when using power tools. Do not install this unit in damp or wet locations, or in close proximity to very hot surfaces. Failure to observe this caution could result in damage to the Industrial Switch and cables.
Continued on next page
8 |
