Hardware Installation, Front Panel | TRENDnet TEW-510APB instruction

3. Hardware Installation

Front Panel

The front panel provides LED’s for device status. Refer to the following table for the meaning of each feature.

Power

11a

11g

Ethernet

The Power LED lights up and will keep while the AP is powered on. When the AP goes through its self- diagnostic mode during every boot-up, this LED will flash. When the diagnostic is complete, the LED will be lit continuously.

The 11a LED flashes when there is a successful Wireless-A connection.

The 11g LED flashes when there is a successful Wireless-G connection.

The Ethernet LED lights up when Ethernet port of AP was connected to LAN. When the LED is flashing that indicates the network activity over that port.

User’s Guide

6

Image 6

TRENDnet TEW-510APB manual Hardware Installation, Front Panel, Power 11a 11g Ethernet

Contents

User’s Guide Copyright Statement MAY Contents Introduction Safety Notification Hardware Installation Power 11a 11g EthernetFront Panel Reset Button Ethernet Power AP Default SettingsRear Panel Hardware Installation for Connection to Your local network How to Configuring the Dual Band AP Turn on Power Supply Setup Network Setup Network SetupStatic IP Wireless Wireless Settings Wireless-A Settings User’s Guide Wireless Wireless Mode Wireless MAC Filter Wireless-A Setting Security Mode Wireless Wireless SecurityWireless Security WPA only Wireless Advanced Wireless Settings Advanced WirelessWireless-A Settings Authentication Type Wireless-B/G Settings Authentication Type User’s Guide Administration Management Backup and Restore Administration Reboot AP Administration Firmware Upgrade Firmware Upgrade Administration Factory Defaults Factory Defaults Status Local Network IdentityLocal Area Network Status Wireless Network Wireless Settings Wireless-A SettingsWireless-B/G Settings Status Wireless Statistics Can’t access the AP from a wireless client. Answer Troubleshooting Q & aHow to set the AP to factory default setting. Answer My AP will not turn on. No LED’s light up Answer Limited Warranty Federal Communication Commission Interference Statement FCC Radiation Exposure Statement User’s Guide