Administration Factory Defaults | TRENDnet TEW-510APB specification

4.10 Administration – Factory Defaults

This Factory Defaults allows you to restore the AP’s configuration to its factory default settings.

Factory Defaults

Restore Factory Defaults: Click this button to reset all configuration settings to their default values. Any settings you have saved will be lost when the default settings are restored.

User’s Guide

22

Image 22

TRENDnet TEW-510APB manual Administration Factory Defaults

Contents

User’s Guide Copyright Statement MAY Contents Introduction Safety Notification Power 11a 11g Ethernet Hardware InstallationFront Panel AP Default Settings Reset Button Ethernet PowerRear Panel Hardware Installation for Connection to Your local network How to Configuring the Dual Band AP Turn on Power Supply Network Setup Setup Network SetupStatic IP Wireless Wireless Settings Wireless-A Settings User’s Guide Wireless Wireless Mode Wireless MAC Filter Wireless-A Setting Security Mode Wireless Wireless SecurityWireless Security WPA only Advanced Wireless Wireless Advanced Wireless SettingsWireless-A Settings Authentication Type Wireless-B/G Settings Authentication Type User’s Guide Administration Management Backup and Restore Administration Reboot AP Administration Firmware Upgrade Firmware Upgrade Administration Factory Defaults Factory Defaults Identity Status Local NetworkLocal Area Network Wireless Settings Wireless-A Settings Status Wireless NetworkWireless-B/G Settings Status Wireless Statistics Can’t access the AP from a wireless client. Answer Troubleshooting Q & aHow to set the AP to factory default setting. Answer My AP will not turn on. No LED’s light up Answer Limited Warranty Federal Communication Commission Interference Statement FCC Radiation Exposure Statement User’s Guide