Operation

E-Mail Notification: Select E-Mail Notification from the Network menu to specify when and to whom the DHD Controller sends error and service notification messages via e-mail.

The notification messages are in the following format:

To: [E-Mail Address; see below]

From: do-not-reply@runco.com

Subject: [Type of notification] from Runco DHD-LS Body:

This is an automated message sent from the Runco DHD-LS:

Notification:

[One

of the

following:

Error”

 

“DHD

Error”

/ “Display

“Periodic Service Notification”

“Calibration Data”]

Detailed Description: [ If a DHD Error, one of the following: “Fan Failure 1” / “Fan Failure 2” “Overtemp 1” / “Overtemp 2” “Initialization Failure”

 

If a

Display Error,

a device-specific

 

error message

 

 

If a Periodic Service Notification, the elapsed

 

time since the last

notification

 

If a Calibration Data message,

 

“See Attached File”

]

Serial Number:

[DHD Controller serial number]

Customer Information: [From “Customer Information” sub-menu; see below]

Best Regards,

Runco International, LLC 1195 NW Compton Drive Beaverton, OR 97006 1-800-237-8262

E-Mail Address: To specify the destination e-mail address for error and service notifications, select E-Mail Address from the E-Mail Notification menu. The procedure is similar to that for setting the IP address (refer to IP Configuration on page 48). Enter up to 45 alphanumeric characters.

Error Notification: To have the DHD Controller send a message to the destination e-mail address when a “DHD Error” or “Display Error” occurs, select Error Notification from the E-Mail Notification menu and set it to On.

Error Notification to Runco: To have the DHD Controller send an e-mail message to Runco Customer Support when a “DHD Error” or “Display Error” occurs, select Error Notification to Runco from the E-Mail Notification menu and set it to On.

50

Vistage™ Series Flat-Panel Display Installation/Operation Manual

Page 62
Image 62
Runco V-63HD, V-50HD operation manual If a Display Error