
Operation
•CUE (Chroma Upsampling Error) Correction: Some DVD players use MPEG decoders that do not correctly “upsample” the 4:2:0 format chroma information on the DVD to the 4:2:2 or 4:4:4 format required by the video encoder of the display device.
This
•Remote Code: Select Remote Code from the Miscellaneous menu to set the infrared (IR) code set to which the DHD Controller will respond. By default, it is set to 17. You can change this setting if either:
•Another device in the theater (a DVD player, for example) is responding to commands from the DHD Controller remote control (Figure
•You have multiple DHD Controllers and want to control them independently, as opposed to broadcasting commands from a single remote to all of them. In this scenario, you can use multiple remotes programmed to use different IR codes. Or, you can use a single remote and change the IR code as needed to address a specific DHD Controller.
Use the serial command REMOTECODE [0 ... 31] to change Tip the IR code to which the controller will respond (refer to
Miscellaneous Commands on page 63). Then, change the code sent by the remote to match as described below.
When you change a remote code on the DHD Controller, you must
DHD Controller remote control to send that same code. To do this:
1.Press and hold the LIGHT button on the remote control for approximately three seconds, or until the LED on the remote lights solid red.
LIGHT
ONOFF
2.Enter a new
3.The LED turns off to confirm the code change. If you enter an invalid code, the LED flashes for three or four seconds. Try again, entering a valid code.
Vistage™ Series | 53 |