2. Hardware Installation
Note:
1.Wi-Fi Protected Setup (WPS) allows you to quickly connect to your wireless router or access point. If you would like to use WPS push button setup, please go directly to section 4. Wi-Fi Protected Setup (WPS) Push Button Setup. If your wireless router or access point does not support WPS, continue on to step 1.
2.Do not connect/install the TEW-687GA to your network until instructed to do so. Make sure your computer's network adapter settings are set to obtain an IP address automatically (see troubleshooting section).
1.Connect one end of the provided RJ-45 network cable to the TEW-687GA's LAN port. Connect the other end of the cable to your computer's network port. Then boot up your computer.
2.Connect the Power Adapter to the TEW-687GA
and then to a power outlet. (EU versions will have a power button on the back. Push the power button to the “On” position). Wait 30 seconds for the TEW-687GA to boot up.
