Levelling
Fix the support with two legs by means of washer and nuts, delivered with the cooker, see the figure.
GAS CONNECTIONS
Your cooker is delivered adjusted for the kind of gas stated on the rating plate.
If the appliance is converted to natural gas and the pressure for natural gas is 20mbar, the following methods of connection to the gas supply must be used:
Right Hand Connection (from front)
Ensure that the rubber hose is not in contact with any part of the shaded area shown in the diagram and that the loop of the hose when connected is not in contact with the floor when the appliance is in position.
Left Hand Connection (from front)
Ensure that the rubber hose is not in contact with any part of the shaded area shown in the diagram and the hose is retained in the clamp provided, it will be necessary to fit the maximum length hose when using this method.
Rigid Connection
Where it is not possible to make the connection using a rubber hose, a rigid pipe work connection must be used.
Recommendations when using an appliance flexible connector are as follows:
-For NATURAL the gas installation pipes to the termination point shall comply with:
Specification for installation of
BACK OF THE COOKER
BACK OF THE COOKER
A
Connection of flexible hose
Clamp
21
