Tripp Lite APS700HF owner manual Mounting

Mounting

WARNING! Mount your Inverter/Charger BEFORE DC battery and AC power connection. Failure to follow these instructions may lead to personal injury and/or damage to the Inverter/Charger and connected systems.

Tripp Lite recommends that you permanently mount your Inverter/Charger in the configuration illustrated below. The APS700HF features integral mounting brackets on the front and rear of the unit. The user must supply mounting hardware and is responsible for determining if hardware and mounting surface are adequate to support the weight of the unit. See page 3A for location warnings and cautions.

Using the measurements as shown in the diagram install two user-supplied fasteners A , leaving the heads slightly raised. Slide the unit over the fasteners to engage the mounting bracket slots B . Tighten fasteners. Install two additional fasteners C over the remaining mounting bracket.

C

10.93 in. (27.8 cm.)

B4.31 in.

(10.95 cm.)

A

8 A