10
Switch between the connected computers using any of the following methods:
• TheOSD(OnScreenDisplay)
• Keyboardhotkeycommands
The OSD is also used to adjust various settings.
A confirmation label at the top of your monitor screen identifies which computer is currently
selected.
Toswitchtothenextcomputer,pressandreleasethe[Shift]key,thenpressthe[+]key.
Toswitchtothepreviouscomputer,pressandreleasethe[Shift]key,thenpressthe[-]key.
Note! You can use the [+] key of the alphanumeric section or of the numeric keypad on
a US English keyboard. With a Non-US English keyboard, use the [+] key of the
numeric keypad only.
Installation (continued)

Basic Operation

Keyboard Hotkeys

Operation

Connecting a B050-000 or B051-000 IP Remote Access Unit to the B070-016-19

1.DisconnecttheJumperCableConsoleConnectorsthatarepluggedintothe KVM
Console Ports.
2.PlugtheendoftheJumperCableyoujustdisconnectedintothe LocalConsolePortsof
the IP Remote Access Unit.
3. Plug the PS/2 and VGA connectors from the IP Remote Access Unit into the KVM
Console Ports.
4. For further setup instructions for the B050-000 or B051-000 IP Remote Access Unit refer
to the Owner's Manual that comes with the unit.
Figure 7 Connecting a B050-000 or B051-000 IP Remote Access Unit
201002116 93-2925.indd 10 3/15/2010 11:48:46 AM