7
Up to 100 ft
Figure 5 NetCommander USB Server Interface Unit
Installation (continued)
SIU = Server Interface Unit
Connecting a NetCommander USB Server Interface Unit (Model # B078-101-USB)
1. Connect the B078-101-USB VGA connector to the computers VGA port
2. Connect the B078-101-USB USB connector to the computers USB port
3.ConnectoneendoftheCat5patchcabletotheRJ45port ontheB078-101-USB*
4.ConnecttheotherendoftheCat5patchcabletothedesired RJ45portonthe
 ConsoleKVM.*ThegreenLEDwillilluminatewhentheSIUisconnected
and receiving power.
5. Repeat these steps for each additional USB computer/server you are connecting to the
Console KVM
*Cat5cableshouldbenolongerthan100ft.
1. Plug in the KVM using only the power cord supplied with the unit.
2. Switch ON the Console KVM.
ToresettheKVMswitch,turntheunitoffandthenbackonusingthepowerswitch onthe
back. The Server Interface Units are unaffected by this reset.
Connecting the Power SupplyResetting the KVM Switch
201002116 93-2925.indd 7 3/15/2010 11:48:42 AM