Tripp Lite G1010USB owner manual Storage, Service

Basic Operation (Rear Panel) continued

	Coaxial Protection Jacks (select models only): Gold-plated coaxial “F”
	connectors protect connected equipment by stopping surges on a single DSS
	satellite, cable or antenna line. Connect a coaxial cable from the wall jack
	directly to the coaxial jack labeled “IN.” Connect a coaxial cable from the
	coaxial jack labeled “OUT” directly to the device to be protected. The UPS
Coaxial Jacks	system must always be the first item connected in line from the coaxial wall
	jack. The UPS system must be plugged into a 3-wire grounded AC outlet for
	coaxial line surge protection to work. Make sure cables connected to satellite
	dishes, antennas, etc. are also grounded. Connecting your equipment to these
	jacks is optional. Your UPS will work properly without this connection.
	Battery Replacement Door: Under normal conditions, the original
	battery in your UPS will last several years. Battery replacement should be
	performed only by qualified service personnel. Refer to "Battery
	Warnings" in the Safety section. Should your UPS require battery
	replacement, visit Tripp Lite on the Web at www.tripplite.com/support/
	battery/index.cfm to locate the specific replacement battery for your UPS.

Storage & Service

Storage

To avoid battery drain, all connected equipment should be turned off and disconnected from the UPS. Press and hold the ON/OFF button for one second. Your UPS will be completely turned off (deactivated), and will be ready for storage. If you plan on storing your UPS for an extended period, fully recharge the UPS batteries every three months. Plug the UPS into a live AC outlet, turn it on by pressing and holding the ON/OFF button for one second, and allow the batteries to recharge for 24 hours. If you leave your UPS batteries discharged for a long period of time, they will suffer a permanent loss of capacity.

Service

A variety of Extended Warranty and On-Site Service Programs are available from Tripp Lite. For more information on service, visit www.tripplite.com/support. Before returning your product for service, fol- low these steps:

1.Review the installation and operation procedures in this manual to insure that the service problem does not originate from a misreading of the instructions.

2.If the problem continues, do not contact or return the product to the dealer. Instead, visit www.tripplite. com/support.

3.If the problem requires service, visit www.tripplite.com/support and click the Product Returns link. From here you can request a Returned Material Authorization (RMA) number, which is required for service. This simple on-line form will ask for your unit’s model and serial numbers, along with other general purchaser information. The RMA number, along with shipping instructions will be emailed to you. Any damages (direct, indirect, special or consequential) to the product incurred during shipment to Tripp Lite or an authorized Tripp Lite service center is not covered under warranty. Products shipped to Tripp Lite or an authorized Tripp Lite service center must have transportation charges prepaid. Mark the RMA number on the outside of the package. If the product is within its warranty period, enclose a copy of your sales receipt. Return the product for service using an insured carrier to the address given to you when you request the RMA.

6

201011078 93-3003.indd 6 11/12/2010 1:57:19 PM