3
Model Description
(continued)
Rear Panel View
Wiring the Power Inputs

Using the Converter with the AC-DC Power Adapter

1.Use DIP switch settings to enable power through the AC-DC Power Adapter
(refer to DIPswitch settings section)
2.Verify that the AC-DC adapter conforms to your country’s AC power requirements and
then insert the power plug.
3.Connect the Converter to the network.
Note: Wear a grounding device to safeguard against damage due to electrostatic charge.

Using the Converter with power Over USB

1. Use DIPswitch settings to enable power from the USB port
(refer to DIPswitch settings section).
Note: Please ensure that the DIPswitch is positioned on the USB side of the slider.
2.Install the USB cable. Plug type A connector in the PC’s USB port and the type B
connector in the Converter’s USB port (see Fig. 1).
3.Connect the Converter to the network.
WARNING
Make sure that the PC’s power is turned on.Otherwise the
Converter will not receive power.
Fig. 1: Media Converter with USB power source (Type B-to-Type APlug) and FX/TPconnection
200605219 93-2565 N784 SMC OM.qxd 6/7/2006 3:54 PM Page 3