5
Dip Switch Setting
(continued)
DIP Switch Dip Function
FX FDX FX at full duplex (default)
HDX FX at half duplex
LFP Enable Link Fault Pass-Through (default)
LFP DIS Disable Link Fault Pass-Through
TP FDX TP at full duplex (default)
HDX TP at half duplex when TPat Force
100 TP at 100M (default)
10 TP at 10M when TP at Force
AUTO TP at auto-negotiation (default)
FORCE Force TP at 10M or at half duplex
Note:• You must set DIPSwitch 1 to “FORCE” when DIP Switches 2 and 3 are set to “10” and “HDX”, respectively
For N784-001-SC, DIPSwitch 5 must be set to “HDX”
After resetting the DIPSwitches, you must reboot the Converter to activate the new settings.
Link Fault Pass-Through
Note: The Link Fault Pass-Through (LFP) function is enabled using the DIPswitch. Disable the LFP function by
setting the DIPswitch to the LFP DIS position.
This media converter supports Link Fault Pass-Through (LFP) for TX/FX converter
applications.
Link status on one port is propagated to the other port to notify remote nodes. If the TPport
is unplugged, the converter stops transmitting over the fiber port, causing the remote fiber
link node to fail. The LED will show link failure on both the TPand fiber ports. If the fiber
link fails, the converter restarts auto-negotiation on the TPport, but stays in the link failure
state. This causes the remote TPnode link to fail. The LED also shows the link failure on
both the TPand fiber ports. The figures below show normal status when the link succeeds,
and the error status when TPCable A, Fiber Cable B, or Fiber Cable C fails to connect.
Normal status via a pair of LFPs
Status if TPCable A is broken
Status if Fiber Cable B or C is broken
Note: indicates LNK/ACT LED Lit indicates LNK/ACT LED Off
200605219 93-2565 N784 SMC OM.qxd 6/7/2006 3:54 PM Page 5