Tripp Lite SMART2500XLHG owner manual Guidance and Manufacturer’s Declaration

Basic Operation continued

Power Sensitivity Adjustment: This dial is normally set fully counter- clockwise, which enables the UPS to provide maximum protection against waveform distortions in its AC input. When such distortion occurs, the UPS will normally switch to providing sine wave power from its battery reserves for as long as the distortion is present. In areas with poor utility power or where the UPS’s input power comes from a backup generator, chronic waveform distortion could cause the UPS to switch to battery too frequently, draining its battery reserves. You may be able to reduce how often your UPS switches to battery due to moderate waveform distortion by experimenting with different settings for this dial. As the dial is turned clockwise, the UPS becomes more tolerant of variations in its input power’s AC waveform.

Note: The further the dial is adjusted clockwise, the greater the degree of waveform distortion the UPS will allow to pass to connected equipment. When experimenting with different settings for this dial, operate connected equipment in a safe test mode so that the effect on the equipment of any waveform distortions in the UPS’s output can be evaluated without disrupting critical operations.

Input Breakers: The SMART2500XLHG uses two input breakers to protect your electrical circuit from overcurrent draw from the UPS load. One breaker protects LINE, while the other NEUTRAL. If these breakers trip, remove some of the load and reset them by pressing the breakers in.

Guidance and Manufacturer’s Declaration

Product Information

AC Input Voltage	120V
Input Amp(s)	16A
No. of Phases	Single
Class Type	Class 1
Plug/Connector Type	IEC inlet C20
Operation	Continuous
AC Input Frequency	60Hz
AC Input Protection (Qty./Type/Rating)	Input breaker (2x 20A thermal)
Max AC Leakage Current (uA)	Less than 100uA
Weight	73.3 lbs (33.2 kg)
Contraindication	None

Guidance and Manufacturer’s Declaration—Electromagnetic Emissions

This Medical-Grade UPS is intended for use in the electromagnetic environment specified below. The customer or the user of this Medical-Grade UPS should assure that it is used in such an environment.

Emissions Test	Compliance	Electromagnetic Environment - Guidance
RF Emissions CISPR 11	Group 1	The Medical-Grade UPS uses RF energy only for its internal
		function. Therefore, its RF emissions are very low and unlikely
		to cause any interference in nearby electronic equipment.
RF Emissions CISPR 11	Class B	The Medical-Grade UPS is suitable for use in all
		establishments other than domestic and those directly
		connected to the public low-voltage power supply network
		that supplies buildings used for domestic purposes.

10

12-10-307-93-3181.indb 10 11/2/2012 9:27:49 AM