Mounting
WARNING! Mount your Inverter BEFORE DC battery and AC power connection. Failure to follow these instructions may lead to personal injury and/or damage to the Inverter and connected systems.
Tripp Lite recommends permanent mounting of your Inverter. User must supply mounting hardware and is responsible for determining if the hardware and mounting surface are suitable to support the weight of the Inverter. Contact Tripp Lite if you require further assistance in mounting your Inverter.
Vehicular and Non-Vehicular Mounting
(2012 model only)
• Horizontal Mount • Vertical Mount
Whether mounted horizontally or vertically, the Inverter must be located in an enclosed compartment, shielded from outside weather conditions.
A Using the measurements from the diagram, install two
mm)fasteners into a rigid horizontal surface, leaving the heads slightly raised. B Slide the Inverter forward over the fasteners to engage the mount-
ing feet molded on the front of the Inverter cabinet. Install and tighten addi- tional
unit’s cabinet to provide for adequate ventilation space behind the cooling A fan(s); they should not be removed. The polycarbonate cabinet and mount-
ing feet of your Utility/Work Truck Inverter are durable enough to allow for vertical mounting as well, if your vehicle compartment requires this configuration. For vertical mounting, the control panel of the Inverter should face up.
9.59 in.
(24.35 cm.)
5.57 in. | ▼ |
(14.16 cm.) |
|
5.57 in.
(14.16 cm.)
9.59 in.
(24.35 cm.)
B
5.87 in.
(14.91 cm.)
5.87 in.
(14.91 cm.)
1.64 in.
(4.15 cm.)
Vehicular and
(750 & 1250 models only)
• Horizontal Mount • Vertical Mount
Whether mounted horizontally or vertically, the Inverter must be located in an enclosed compartment, shielded from outside weather conditions.
A Using the measurements from the diagram, install two |
(6 mm) fasteners into a rigid horizontal surface, leaving the heads slightly |
raised. B Slide the Inverter/Charger back over the fasteners to engage the |
mounting slots molded on the bottom of the Inverter/Charger cabinet. |
C Install and tighten two |
mounting feet molded on the front of the Inverter/Charger cabinet. The |
polycarbonate cabinet and mounting feet of your Utility/Work Truck |
Inverter are durable enough to allow for vertical mounting as well, if your |
vehicle compartment requires this configuration. For vertical mounting, |
C
A
4.5 in.
(11.4 cm)
6.75 in. | B | ▼ |
|
| |
(17.1 cm) |
|
|
6.75 in.
the control panel of the Inverter should face up. |
7.87 in.
(20 cm)
(17.1 cm)
7R
