SECTION 4: OPERATING YOUR TILLER
WARNING: Read, understand, and follow all instructions and warnings on the machine, in this manual and the Briggs & Stratton Owner/ Operator manual packed with your unit before operating the tiler.
Safety Interlock System
IMPORTANT:Your tiller is equipped with an interlock system for the protection of the operator. If the interlock system should ever malfunction, do not operate the tiller. Contact an authorized service dealer.
•The Wheel Engagement Handle must be in the closed position in order to engage the tines
•The Wheel Shift Lever must be in the FORWARD position in order to engage the tines.
•The Wheel Shift Lever cannot be moved out of the FORWARD position unless the Tine Engagement Lever is in the OFF position.
•The tines will automatically stop if the operator releases the Wheel Engagement Handle.
•The wheels will automatically stop if the operator releases the Wheel Engagement Handle.
7.Set the tilling depth by moving the depth regulator lever rearward, then either up or down into the desired depth setting. Refer to Depth Regulator Lever on Page 10.
NOTE: Move the Depth Regulator Lever into the “travel” position (lever all the way down) so that the tines clear the ground. Use this position when practicing with or transporting the tiller. When you are ready to begin tilling, move the Depth Regulator Lever into the desired depth setting. Refer to Depth Regulator Lever on Page 10.
Starting Engine
•Move choke control lever to CHOKE position.
WARNING: Do not operate the tiller if the interlock system is malfunctioning. This system was designed for your safety and protection.
NOTE: A warm engine may not require choking.
•Move throttle control lever to FAST (rabbit) position.
Pre-Start Checklist
Do the following before starting the engine.
1.Check unit for loose or missing hardware. Service as required.
2.Check motor oil level. Refer to separate Briggs & Stratton Operator/Owner Manual.
3.Check that all safety guards and covers are in place.
4.Check air cleaner and engine cooling system. Refer to separate Briggs & Stratton Operator/Owner Manual.
5.Select a tine direction (Refer to Tine Direction Selector on page 10).
6.Fill the fuel tank with gasoline as instructed in the separate Briggs & Stratton Operator/Owner Manual packed with your tiller. Read instructions carefully.
WARNING: Gasoline is highly flammable and its vapors are explosive. Follow gasoline safety rules found on Page 3 in this manual, and in the separate Briggs & Stratton Operator/Owner Manual. Failure to follow gasoline safety instructions can result in serious personal injury and property damage.
•Grasp the starter handle and pull the rope out slowly until resistance is felt. When it becomes slightly harder to pull the rope, slowly allow the rope to recoil. Then pull rope with a rapid, continuous, full arm stroke. Keep a firm grip on starter handle.
•Maintain a grip on the starter handle and allow the rope to recoil slowly.
•Repeat the previous steps until engine starts. When engine starts, move choke control gradually toward the RUN position until the engine is running smoothly.
WARNING: Never run the engine indoors or in a poorly ventilated area. Engine exhaust contains carbon monoxide, an odorless and deadly gas.
11
