WARNING: Do not attempt to shred, chip, or vacuum any material larger than specified on the machine or in this manual. Personal injury or damage to the machine could result.
IMPORTANT: The flail screen is located inside the housing in the discharge area. If the flail screen becomes clogged, remove and clean as instructed in MAINTAIN- ING YOUR Chipper shredder VACUUM. For best performance, it is also important to keep the chipper blade sharp.
WARNING: Do not at any time make any adjustments without first stopping engine and disconnecting spark plug wire.
Using The Hose Assembly
1.Place nozzle/hose vac handle in the bottom position on the nozzle to redirect vacuum to the hose assem- bly. See Figure
2.The spring loaded pin must be in the second hole of the hose adapter to operate the hose assembly.
3.Unhook the hose from upper handle bracket and grasp the hose handle to guide while vacuuming yard waste such as leaves or pine needles in hard to reach places.
Nozzle Height Adjustment
The nozzle can be adjusted to any six positions, rang- ing from 5/8” to 4 1/8” ground clearance. The nozzle height has to be adjusted according to chipper shredder conditions.
1.Depress nozzle height adjustment lever towards wheel. See Figure
2.Move the height adjustment lever forward or backward to adjust the nozzle upwards or downwards. Make sure both levers are in the same position.
3.Release lever towards deck.
NOTE: In general, raise the nozzle height to vacuum a thick layer of leaves. Lower the nozzle height for smoother surfaces.
Figure
Figure
4
Operating
Your
Chipper
Shredder
Vacuum
WARNING
Do not attempt
to shred, chip, or
vacuum any material larger than specified on the machine or in this manual. Personal injury or damage to
the machine could
result.
Do not at any time make any adjust- ments without first stopping engine and disconnecting spark
plug wire.
13
