Troy-Bilt 70 warranty Attaching The Bag, Attaching The Blower Chute, A B C, If Equipped

Attaching The Bag

7.Grasp bag handle with one hand and slide locking rod on mounting bracket with other hand toward engine. Use the end of mounting bracket as leverage when sliding the locking rod.

a.Slip bag over the rim of the discharge opening and release locking rod to secure bag in place. See Figure 3-7.

b.Snap bag clip to the top of the lower handle.

c.Place the lower straps on the bag over the top of lower handle, hooking them on the studs. See Figure 3-7.

NOTE: The bag/chute switch button attached to the mounting bracket must be fully depressed by the tip of front tab on bag handle when securing the bag or engine will not start.

Attaching The Blower Chute

(If Equipped)

NOTE: The bag must be removed before installing the blower chute.

8.a. Grasp blower chute with one hand and slide locking rod on mounting bracket with other hand toward engine. Use the end of mounting bracket as lever- age when sliding the locking rod. See Figure 3-8.

b.Slip blower chute over rim of discharge opening and release locking rod to secure chute in place.

c.Raise the nozzle height to the highest setting when using the blower chute. Refer to nozzle height adjustment in the Operating Your Chipper/ Shredder Vacuum section.

NOTE: The bag/chute switch button attached to the mounting bracket must be fully depressed by the tip of front tab on the blower chute or engine will not start.

A

B

C

Figure 3-7

Figure 3-8

3

Setting Up

Your

Chipper

Shredder

Vacuum

NOTE: The bag must be removed before installing the blower chute.