Troy-Bilt 70 warranty Attaching The Handle

Attaching The Handle

1. Remove the hairpin clips from the handle brackets and

remove the carriage screws and wing nuts from the lower handle.

Place the bottom holes in lower handle over the	3
a. pins on the handle brackets and secure with
hairpin clips. See Figure 3-2.
b. Insert carriage screws through upper hole in lower	Setting Up
handle from the inside and secure with wing nuts.
See Figure 3-2.	Your
2. a. Unfold the upper handle until it aligns with lower
handle. Make sure the rope guide is on the right	Chipper
side of upper handle. See Figure 3-3.	Shredder
IMPORTANT: Make sure the cables are routed outside
the lower handle. Also, do not crimp the cables while	Vacuum
lifting up the handles.
b. Secure the two handles by tightening the star	Figure 3-2
knobs (carriage bolts must be seated properly into
the handle). See Figure 3-3.	Rope Guide
3. Pull the two cable ties attached to the cables tight
approximately 8 inches from each cable end and place
the cables into the cable guide.

4.Loosen the wing nut that secures the rope guide to the right side of upper handle.

a. Pull the starter rope out of the engine slowly. See	B		IMPORTANT
Figure 3-4.			Make sure the cables
b. Slip the starter rope into the rope guide. Tighten		A	are routed outside the
the wing nut. See Figure 3-4.			lower handle. Also, do
			not crimp the cables
			while lifting up the
			handles.

Figure 3-3

B

A

Figure 3-4