TB4HB EC

4-Cycle Electric Start Capable Handheld Blower

Operator’s Manual

Removing Unit From Carton

Assemble The Unit

 

 

 

 

 

1

2

Remove all contents from

Insert the upper blower

the carton.

tube into the blower outlet

 

and turn it clockwise until it

 

locks into place.

3

Install the lower blower tube onto the upper blower tube and turn it clockwise until it locks into place.

4

Place the unit on a level surface, remove the oil plug from the crankcase, and pour the entire bottle of oil into the fill hole.

Tools Required:

On/Off Switch

Throttle Control

• Flathead Screwdriver

 

 

 

 

 

Primer Bulb

Blower Outlet

 

Starter Rope

Upper Blower Tube

 

 

Lower Blower Tube

Oil Plug

 

 

 

ENGLISH — PAGE 1

Assemble The Unit

 

Starting The Unit

 

Primer

Bulb

5

Place unit on a level surface. Fill fuel tank.

Starting The Unit

10 X

6

Press primer bulb 10 times, or until fuel is visible

7

8

Move choke lever to

Crouch in starting position.

Position 1.

 

DIDN’T START?

Repeat the starting instructions.

IF engine fails to start after 2 attempts, move choke lever to position 3 and pull the starter rope until engine starts

IF unit still fails to start, refer to operator’s

manual for additional starting and

troubleshooting information

PAGE 6

 

5 X

 

3-5 X

 

 

19

10

11

13

14

12

DO NOT squeeze throttlePull rope 5 times.

Move choke lever to

Pull rope 3-5 times to startContinue to squeeze

Continue to squeeze

control.

 

Position 2 .

engine. Squeeze throttle

throttle. Move choke lever

throttle. Warm unit for an

 

 

 

control and allow unit to

to Position 3.

additional 60 seconds to

 

 

 

warm up for 30-60 seconds.

 

complete warm-up. Unit

 

 

 

 

 

may be used during this

 

 

 

 

 

time.

FRANÇAIS —
ESPAÑOL — PAGE 11

IMPORTANT: READ OPERATOR’S MANUAL THOROUGHLY AND FOLLOW THE SAFE OPERATION PRACTICES WHILE OPERATING THE UNIT.

NEED HELP? Call 1-800-828-5500 in U.S. or 1–800–668–1238 in Canada

769-06521 P00

03/11