Troy-Bilt RZT 50 manual Adjustments, Adjusting The Operators Seat

SECTION 3: ADJUSTMENTS

ADJUSTING THE OPERATORS SEAT

•To adjust the position of the seat, move and hold the seat adjustment lever toward the left. Slide the seat forward or rearward to the desired position; then release the adjustment lever. Make sure seat is locked into position before operating the tractor. See Figure 20.

Seat

shoulder screw removed earlier. Fasten with the hex insert flange lock nut and tighten until snug.

•Insert the hex screw w/washer through the control lever slot and the pivot bracket.Thread the flange lock nut onto the screw, but do not tighten now.

•If you are going to adjust the control levers forward or rearward, proceed to the next step. If not, fully tighten the flange lock nut.

Pivot Bracket

Move Lever to Left

Adjustment

Lever

Flange

Lock Nut

Height

Adjust

Holes

Slot

Control Lever

Flat Washer

Hex Screw

Shoulder Screw

Figure 20

ADJUSTING RH & LH DRIVE CONTROL LEVERS

The RH and LH drive control levers can be adjusted up or down and fore-and-aft for the comfort of the operator. The drive control levers can be placed in either of two height positions, and/or can be moved forward or rearward within the range of the slot in each control lever mounting bracket.

To adjust the drive control lever height, proceed as follows:

•Remove the flange lock nut, flat washer, and hex screw securing the lever to the pivot bracket.

•While supporting the control lever to keep it from falling, remove the hex insert flange lock nut and shoulder screw from the bottom of the control lever and pivot bracket. Refer to Figure 21.

•Reposition the control lever to align with the other set of holes in the pivot bracket and insert the

Figure 21

To adjust the drive control levers forward or rearward, proceed as follows:

If not already loose, loosen the flange lock nut and rotate the control lever either forward or rearward to the desired position. See Figure 21.

NOTE: If the control lever is too tight to move, slightly loosen the hex insert flange lock nut and shoulder screw at the bottom of the control lever.

•Tighten the flange lock nut to fix the control lever in the adjusted position

•Repeat the above procedure to adjust the other control lever into the same position. Adjust so that both levers are even with each other when in the neutral position.

22