TIPS AND HOW HRC WORKS
CHAPTER FOUR: HRC
Increase speed and incline gradually to slowly increase your heart rate to within 10 bpm of your target. For best results, you should take about five minutes to get to that point.
The treadmill operates in a manual control mode during the
It is important that you start at a low level of effort and gradually increase your work load over several minutes until you approach your target heart rate. This allows your body to adapt to your workout. Increasing work load gradually will allow you to enter the HRC stage without overshooting your target.
Warming up too fast may cause you to overshoot your target. If this occurs, it may take several minutes before the computer software can control your heart rate. You may overshoot and undershoot your target for several minutes until stable control is achieved.
To raise your heart rate in HRC mode, speed will always increase until maximum speed is attained, followed by incline (if incline is used in the workout).
To lower your heart rate in the HRC mode, incline will always decrease until zero incline is reached, followed by speed (if incline is used in the workout).
Speed changes are in 0.1 mph increments. Incline changes are in 0.5% incline increments. This is equal to between 0.10 and 0.15 METs.
TIPS ON THE WARM UP STAGE
HOW THE HRC SYSTEM CONTROLS YOUR HEART RATE
|
| 28 | |
CS TREADMILL OWNER’S GUIDE | |||
| |||
