SUPPORTS (FIGURES 1 AND 2)
::Place the rear support under the frame and fasten it with two hex screws and washers.
::Tilt the cycle back so that it rests on the rear support and seat. Push the plastic covers into place at the ends of the front support. Turn the cycle back to upright position.
HANDLEBAR (FIGURES 3 AND 4)
::Expose the wire coming from the frame tube by unwrapping the tape that covers it, and then connect it to the counterpart in the handlebar support tube. Ensure that the joint is securely locked by gently pulling the wire.
::Thread the wire carefully inside the frame tube and push the handlebar support tube into place inside the frame tube, so that the fastening screws are on the front of the tube.
::NOTE! Use the enclosed Allen key to tighten both fastening screws through the holes in the tube. Tighten the fastening screws by turning them
::Pull out the tape protecting batteries from the side of the meter. The meter becomes activated.
::Remove the protecting film from the display.
4 ::
ADJUSTMENTS ::
CORRECT EXERCISING POSITION
The seat height should be set so that the heal of the foot reaches the pedal with the leg straight and the pedal at its lowest point. To raise or lower the seat: First turn the locking knob one turn
the seat locks into
place. Turn the locking knob clockwise to tighten. NOTE! Always make sure that the locking knob is properly fastened before starting to exercise!
The scale on the seat tube helps you remember the seat height that suits you best. The seat can be inclined forward or backward by turning the green adjustment ring below the saddle. The seat inclines forward when the ring is turned clockwise, and back when the ring is turned counter- clockwise. Do not try to adjust seat inclination when you’re sitting on the seat - the ring won’t turn.
HANDLEBAR SET-UP
Loosen the grey knob in front of the handlebar and adjust the handlebar position until your training position feels comfortable. Tighten the grey knob carefully.
PEDALS
Select strap tightness, set the appropriate strap hole on the retainer from below and pull forcibly upward. Especially when the equipment is new, the strap fastening may seem relatively tight.
PEDALLING RESISTANCE
To increase or decrease resistance, turn the adjustment knob at the top of the handlebar support tube clockwise (+ direction) to increase resistance and counterclockwise (- direction) to decrease resistance. The scale above the knob
:: 5
