METER ::
RESET
Pressing Reset always resets the value on the display.
SET
Press Set key for 2 seconds to set units of measurement.
::Default units are rpm, km and kcal.
::To change the units press the - or + key until the desired units are displayed.
::To measure speed you can set either revolutions per minute, (rpm), kilometres per hour (km/h) or miles per hour (mph). Energy consumption measurement can be set for kilocalories (kcal) or kilojoules (kJ).
::In addition to rpm you can also select either kilometres (km) or miles as distance measures. If km/h is selected as the unit to measure speed, km will automatically be the unit for distance. The same applies to the units mph and miles.
::The user interface automatically returns to the main display 5 seconds after the Set key was last pressed.
::Press the Reset key to exit the setting function without saving the adjustment. This resets the readings on the main display.
8 ::
MAIN DISPLAY ::
When you turn the user interface on, the display shows the following exercise parameters:
1.Efficiency (W)
::Figure indicates exercise efficiency in Watts, which depends on pedalling speed and resistance adjustment.
2.Energy consumption (kcal/kJ)
::Displays cumulative energy consumption
3.Speed (rpm / km/h / mph)
::Default setting is rpm (pedal revolutions / minute).
4.Pulse
::Heart rate transmitter belt or an ear sensor is required.
::If the user interface does not receive a
NOTE! Always disconnect the ear sensor from the user interface if using a heart rate transmitter belt; the ear sensor will interfere with the heart rate transmitter.
5.Time
::Displays the exercise time elapsed between 0:00 - 59:59 minutes and between 1:00 - 10:00 hours in 1 minute increments.
::Time display stops if speed falls to zero.
6.Distance (km / miles)
::Default display setting is km.
::Displays the distance travelled during the workout in km (or miles) to two decimal points up to 9.99 km (or miles) and with one decimal point up to 99.9.
:: 9
