Tunturi E 2 owner manual Transport and Storage, Maintenance, Technical Data

TRANSPORT AND STORAGE ::

Follow these instructions when carrying and moving the cycle about, because lifting it incorrectly may strain your back or risk other accidents:

Stand behind the device. Grip the seat with one hand and the handlebar with the other, and set your foot on the rear support. Tilt the device so that it rests on its transport wheels. Wheel the device to move it on these transport wheels. Lower the device while holding on to the handlebar and remain behind the device all the time.

If the device is not used for a period of time, the transmission belt may become temporarily distorted. This can lead to slightly uneven pedalling. However, after a few minutes of use the effect disappears as the belt returns to its original form.

To prevent the cycle malfunctioning, store in a dry place with as little temperature variation as possible and protected from dust.

MAINTENANCE ::

The equipment requires very little maintenance. Check, however, from time-to-time that all screws and nuts are tight.

::After exercising, clean the equipment with a soft, absorbent cloth. Sweat may cause corrosion: we recommend therefore that you protect all metal surfaces outside the plastic covers with teflon or car wax. Do not use solvents. The magnetic brake is

based on magnetic resistance; resistance level is measured electronically and shown as a watt-reading on the display.

::Due to the measurement system, your Tunturi ergometer need not be recalibrated when assembled, serviced and used according to this owner’s manual.

If the meter display shows text “LO BAT”, change the batteries. Loosen the 6 fastening screws in the top of the meter. Carefully lift the top, cut the ribbon over the batteries and remove the old batteries. Place the new batteries (3 x 1.5 V AA) in the holder and replace the top of the meter.

10 ::

If the display malfunctions proceed as follows:

Loosen the 6 fastening screws in the top of the meter. Carefully lift the top and turn it so that the wire joint is exposed. Detach the joint by pressing the lever towards the wire and pull the wire connector out. Be careful not to let the wire drop inside the tube. If the bottom of the meter is damaged, remove it by unscrewing the 2 fastening screws at the bottom. Defective parts should be sent to your Tunturi dealer. Ensure that the meter wire is securely locked in place when replacing the top of the interface by gently pulling on the joint.

NOTE! Despite continuous quality control, defects and malfunctions caused by individual components may occur in the equipment. In most cases it is unnecessary to take the whole device in for repair, as it is usually sufficient to replace the defective part. If the equipment does not function properly during use, contact your Tunturi dealer immediately. Always give the model and serial number of your equipment. The location of the serial number sticker is shown on the inside cover. Please also state the nature of the problem, conditions of use and purchase date.

If you require spare parts for your equipment, please contact your dealer with the model, equipment serial no. and spare part number of the required part. There is a spare part list at the back of this manual. Use only components and parts mentioned in the spare part list.

TECHNICAL DATA ::

Length	96 cm	Height	124 cm
Width	69 cm	Weight	35 kg

All Tunturi models and user interfaces meet the requirements of the EU EMC Directives on electromagnetic compatibility (89/336/EEC) and electrical equipment designed for use within certain voltage limits (73/23/EEC). This product therefore carries the CE label.

All Tunturi ergometers meet CEN precision and safety standards (Class A, EN-957, parts 1 and 5).

:: 11