MEMORY FUNCTION
The Memory function requires the use of a user code: the exercise is saved under the selected user code. You can save 5 exercises under each user code.
SAVING YOUR OWN PROFILE:
1.You can save preset profiles once the exercise is completed, or after finishing the exercise by pressing
STOP once. If you want to save your Manual or HRC workouts, finish the exercise by pressing STOP once.
Save your exercise by pressing MEM.
2.The display prompts for a memory slot (SAVE AS OWN
3.If there are no empty memory slots, replace a previous profile with a new one. The display then prompts you
to confirm (REPLACE OWN
4.SAVED AS OWN
save. The console will automatically switch to its initial state.
NOTE! To save a profile, you need to exercise for 10 minutes or more.
USING YOUR OWN PROFILE:
1.Select your user code.
2.Press MEM.
3.Use JOGWHEEL until the signal light indicates the desired own profile
Race function) with the JOGWHEEL key.
4.Press JOGWHEEL to confirm your selection.
5.Press START to begin the profile.
6.The RERUN function allows you to scale your own profile and save the changes.
RACE FUNCTION
To race against a previously saved exercise, select RACE in the Own Profile menu.
1.Press START. The exercise begins and the belt starts moving.
2.Adjust the speed according to your fitness level either manually or using the PSC function.
3.The console display shows information on profile progress and any changes ahead.
4.Once the profile has been completed, the
MAINTENANCE
The equipment is safe to use only when periodically maintained and inspected for faults and wear. Do not attempt any servicing or adjustment other than those described in this manual. Any other servicing must be performed by an authorized service representative. Check the tightness of all fixing screws once a year. Do not overtighten. Defective components must be immediately replaced: the equipment must not be operated with any defective components.
CLEANING AND LUBRICATING THE TREADMILL
FAILURE TO LUBRICATE YOUR TREADMILL MAY INVALIDATE THE PRODUCT’S WARRANTY!
Wipe the treadmill surfaces, especially the handlebars and console from dust with a damp cloth or towel. Do not use solvents. Use a small vacuum nozzle to carefully vacuum around all visible components (belt, running deck, side rails etc.). Also keep the area near the treadmill clean. While in use, the treadmill gathers dust that may cause problems in the operation of the equipment.
In average domestic use (a maximum of 60 minutes a day), you should check the lubrication once a month
–however, lubricate the belt only if needed. In more demanding use, the lubrication needs be checked at shorter intervals. This is best done before you begin a training session. Check the lubrication as follows:
1. Ensure the treadmill is powered off! Step on the treadmill belt and stand steadily where you normally run on the belt.
2. Take hold of the horizontal handlebar and push the belt with your feet so that it slides back and forth. The belt should move softly and evenly, without a sound. 3. If you notice jerky movement or if the belt will not slide check for lubrication by sliding your hand under the belt. Lubricate the running deck according to the following instructions:
NOTE! Lubricate your treadmill only with
IMPORTANT! Treadmills need constant lubrication. After not using the machine for a while, the deck could dry out and needs to be lubricated. Make sure you check after long periods if the belt needs lubrication. To lubricate open the small caps at the end of the treadmill with a small coin. And squeeze half the bottle of
11 |
| |
T70 & T80 - OWNER’S MANUAL | ENGLISH | |
