Turbosound LMS-D4 user manual Rear Panel Functions

user manual

LMS-D4

Rear Panel Functions

1

STAR ROAD, PARTRIDGE GREEN, WEST SUSSEX, RH13 8RY

THIS APPARATUS MUST BE EARTHED.

DO NOT EXPOSE THIS UNIT TO MOISTURE.

DO NOT REMOVE THIS COVER.

NO USER SERVICEABLE PARTS INSIDE.

REPLACE FUSE WITH SAME TYPE ONLY.

MADE INTHE E.U.

LMS-D4	OUTPUT 4	OUTPUT 3	OUTPUT 2	OUTPUT 1	RIGHT / MONO IN	LEFT IN
SERIAL NO.:						PIN1=SHIELD
						PIN2=HOT
						PIN3=COLD
POWER
~ 50/60Hz 100V-240V
Fuse Sticker

2 4 3

1.Mains Power - Connected via a standard IEC socket. A compatible power cord is supplied with the unit.

2.Mains Fuse - Located in a finger-proof fuseholder integral to the mains inlet. Always replace this fuse with the correct type as shown on the rear panel legend. (N.B. A spare fuse is located in this holder.)

3.Audio Inputs - 3 pin female XLR connectors are provided for each audio input. All terminations are electronically balanced, pin 2 Hot, pin 3 Cold and pin 1 Screen (shield). The input sensitivity is pre-set at 0db. The overall default gain of the unit is set at -14dB. Please note that when the unit is operated in mono 3-way mode, the input signal is to be fed into the RIGHT / MONO connector.

4.Audio Outputs - 3 pin male XLR connectors are provided for each audio output. All terminations are electronically balanced, pin 2 Hot, pin 3 Cold and pin 1 Screen (shield). Please note that connecting to unbalanced amplifier inputs should be avoided as it will result in a 6 dB loss of level, and limiters settings will be out by 6 dB.

LMS-D4 user manual Page 7