LISTINGS AND CODE APPROVALS
THE BUILDERS BOX SERIES HAS BEEN TESTED AND APPROVED IN ACCORDANCE WITH THE
CSA xxxxxxx No.xxxxxxx STANDARDS FOR FIXED AND LOCATION
DEDICATED ELECTRIC ROOM HEATERS.
MODEL SPECIFICATIONS
MODEL |
|
| RATED POWER | REMOTE |
|
NUMBER | DESCRIPTION | VOLTAGE | WATTS | CONTROL | AMPS |
33EB304AAS | 33” STANDARD | 120/208/240 | 1440/2100/2700 | YES | 12.00/10.10/11.25 |
|
|
|
|
|
|
39EB364AAS | 39” STANDARD | 120/208/240 | 1440/2100/2700 | YES | 12.00/10.10/11.25 |
!!! WARNING !!!
THE INSTALLATION OF THE FIREPLACE UNIT MUST COMPLY WITH THE APPLICABLE LOCAL AND/ OR NATIONAL ELECTRICAL CODES AND UTILITY REQUIREMENTS.
THIS INSTALLATION SHOULD BE ENTRUSTED TO DULY QUALIFIED
PERSONNEL WHERE REQUIRED BY LAW.
STEP - BY - STEP INSTALLATION OVERVIEW
(please read all instructions before installation)
1)Rough in framing following the
recommended dimensions. (see figure 1) 2) Allow at least 8” of service cable for
connecting power supply wire to junction box on fireplace insert when installing before finishing wall. Allow up to 4 feet of service cable for connecting power supply wire to junction box on fireplace insert after finishing wall.
3)Remove the outer jacket and strip the individual conductors ½” from end.
4)Loosen the screw securing the junction box cover and remove the cover.
5)Place unit in position in the framed opening, level with shims if necessary
and attach unit to frame using mounting flanges provided ( see Section 3).
6)Wire a dedicated, properly fused circuit with a 15 amp rating for the appropriate voltage
(120, 208/240). (See table above)
7)Install wall thermostat as outlined on
page 10 section E
8)Place all connections inside the junction box. Secure the junction box cover on the unit.
When installing a cable clamp make sure it grips only the jacket of the service cable and thermostat wire.
!POWER SELECTION WARNING!
! | This unit is factory wired for 110 volt power supply. | ! |
If 208/240 volt operation is required, slide the voltage switch | ||
and reconfigure the wiring accordingly (see figure 2). | ||
| Wires L1, L2, N & G are attached to the rear of |
|
| the junction box for easy access. |
|