Section 3: Voltage Selector Switch Location
Important:
Ensure that the incoming power supply voltage matches the setting of the voltage selector switch!!!!!!
The voltage selector switch is located inside the exhaust panel on the top left hand corner. Carefully insert a flat headed screw- driver inside the exhaust panel through the hole in the mesh to change the switch from 240 volts (230 position) to 120 volts (115 position). The unit ships with the switch in the 115v position.
Caution:
When changing the voltage selector switch from 240 volts to 120 volts ensure that the power supply is turned off.
When wiring the unit for 208/240 volts the voltage selector switch should be in the 230 volt position. (see figure 2)
When wiring the unit for 120 volts the voltage selector switch should be in the 115 volt position. (see figure 2)
Voltage Selector Switch: Figure 2 |
230 |
115 |
