Tyco Electronics MM102014V1 MM102014V1, Rev. G , 5.18.1 Password Entry

MM102014V1, Rev. G

To perform a command from the keypad, press the * key followed by one of the pre-set function keys as

follows:

*0 Log-off command: *0## (logs the user off the system). See page 28 for

additional information.

*1 Log-in command: *1<User ID> # <Password> ## (required for encryption).

See page 27 for additional information.

*4 V-TAC Scene-Of-Incident (SOI) channel attachment command: *4<LC

number>#<band>, where LC represents the Licensed Channel number

authorized for SOI radio communications and band is the number assigned to

each frequency band. For example, if LC 25 800 MHz (band 0) is being used

for SOI, enter: <*4 25 # 0 #> Do not enter spaces.

(Exit SOI mode with *4#) See page 52 for additional information.

*5 Single Site Channel command: *5<SMR/NPSPAC channel>#<band> (See

SOI mode instruction above).

*6 Load Default Personality command: *6#. This command applies only if the

radio is not voice-registered on the network.

*7 Initiate Selective Alert command: *7<Target ID>#[Choose Message]#. See

page 39 for additional information.

*8 Radio-to-Radio Call command: Selective call number # (PTT to dial). See

page 38 for additional information.

*9 Public Switched Telephone Network (PSTN) Call command: See page 40

for additional information.

*32 Begin Manual Encryption command: *32<Pre-Determined Encryption Key

of Up To 16 Digits># See page 46 for additional information.

*33 End Manual Encryption command: *33#.

*61 Initiate XCOV Mode: Initiates extended coverage for individual users.

*62 Initiate XCOV-TG Mode: Initiates extended coverage for a talk group.

*60 Exit XCOV or XCOV-TG Mode: Returns to the normal mode.

When entering letters or numbers from the keypad that has if two or more adjacent

characters represented by the same key on the keypad, the pound (#) key must be pressed

after all but the last of the adjacent characters. For example, to enter MACOM6, press the

following keys: 6 key twice (M), 2 key twice (A), # key, 2 key 4 times (C), 6 key 4 times

(O), # key, the 6 key twice (M), # key, and then the 6 key once (6). Press the # key twice

to complete the entry.

Password entry requires a DTMF microphone. Password characters are encrypted on the display using

symbols to indicate the entry. The encryption symbols for each entry will appear in the display as they are

scrolled through, for example: ‘-’ and ‘+’. Press the # key twice to complete the entry process. Refer to

the above NOTE for more details.

If the radio is configured for alpha-numeric passwords and the password has consecutive duplicate

numbers (“MES33” for example), enter # between the consecutive duplicate numbers so the radio will not

interpret the entry as a letter (“D” in this example). If the radio is configured for numeric-only passwords,

do not enter # between duplicated numbers.