Installation & Service Manual | N5D, N5DH, N5DL, N5DSC |
CLEANING AND SANITATION
Component Removal and Installa- tion Instructions for Cleaning
Mirrors
1.Remove mounting screws and end mold- ing of mirror
2.Carefully grasp and lift mirror section until bottom edge clears the lower mirror track.
3.Carefully lower mirror out of upper mirror track and remove from case.
4.After cleaning, replace in reverse order.
Shelves and Shelf Brackets
1.Remove product from shelves.
2.If shelf has a light, unplug the light cord from the socket in the rear duct panel. Completely insert socket cover in the light socket to protect the receptacle.
3.Push shelves back and then lift up and out to remove them from the shelf brackets.
4.Remove shelf brackets from slots in rear uprights.
5.After cleaning, replace in reverse order.
Bottom Trays
1.Remove product from bottom of case.
2.Grasp and lift out each of the bottom trays from the case interior.
3.After cleaning, replace in reverse order.
Front Air Ducts
1.Remove lower trays, see this page.
2.Lift out front air duct sections.
3.After cleaning, replace in reverse order.
Rear Duct Panels
(w/o Shelf Light Sockets)
1.Remove shelves and bottom trays, see above.
2.Remove mounting screws and rear duct panels from case.
3.After cleaning, replace and secure rear duct panels in reverse order.
(with Shelf Light Sockets)
1.Remove mirrors, shelves and bottom trays, see this page.
2.Remove mounting screws from rear duct panel.
3.Slowly lift out rear duct panel until the shelf harness connector near the top of the panel can be accessed.
4.Disconnect shelf harness connector and complete removing the rear duct panel.
WARNING
Rear duct panels with electrical recepta- cles can be cleaned without removing the electrical receptacles. Do not get moisture on electrical wires when cleaning under this cover. Moisture on wires could cause premature product failure and/or personal injury or death from electrical shock.
5.After cleaning, reconnect the shelf har- ness connector: install the top socket assembly: replace and secure rear duct panels in reverse order.
Discharge Air Honeycomb
1.Loosen screws securing rear retainer plate.
NOTE
Note position of the honeycomb grid dur- ing removal so it can be reinstalled the same way.
2.Slide rear retainer plate back until the honeycomb grid sections can be removed from the top duct.
CAUTION
Improper installation of the honeycomb grid section could result in improper air flow and/or poor refrigeration.
3.After cleaning, replace honeycomb grid sections as they were removed and secure with the rear retainer plate and screws.
January, 2001 | Page 13 |
