User’s Manual
NOTE
After completing the installation, turn on the water and recheck water and drain connection for leaks. Apply additional tightening if needed. Do NOT use thread sealing compound or tape.
NOTE
Route the water supply line through the clip on the sidewall of the unit in such a way as to prevent the line from coming in contact with any internal components other than the solenoid valve (see Figure 5). Normal operation creates some vibration. A water supply line contacting an internal component or cabinet wall may cause excessive noise during operation or damage to the line.
7.
8.Install access panel.
9.Install the grille. See GRILLE INSTALLATION.
10.Plug in the power cord.
11.Gently push the unit into position. If desired the unit may be recessed into cabinet or wall.
12.Allow at least
LEVELING THE UNIT
NOTE
It is extremely important that the unit is level. If it is not level, the ice mold will not fill evenly. This can cause a reduction in ice rate, uneven sized cubes or water spilling into the storage area which will cause the ice in the bin to melt pre- maturely. Remember that floors near drains have a tendency to slope towards the drain.
1.Use a level to check the levelness of the ice maker from front to back and from side to side (see Figure 10).
2.If the ice maker is not level, adjust the feet on the corners of the unit as necessary (see Figure 11).
12