13.Replace three plastic plugs removed in step 8 into holes on top of unit. Replace screws in holes in bottom of unit, opposite side.

14.Reinspect door seal and alignment. Adjust if needed.

15.Reinstall grille (1 screw).

ALIGNING THE DOOR

For proper door alignment:

1.Loosen top and bottom hinge screws (see Figure 15).

2.Align door squarely with cabinet.

3.Assure gasket is firmly in contact with cabinet all the way around the door (no gaps).

4.Tighten bottom hinge screws.

5.Tighten top hinge screws.

NOTE

Make sure that the door gasket is not pinched too tightly on the hinge side of the door.

CUSTOM DOOR PANEL INSERT

INSTALLATION

A custom door panel insert can be installed in your U-Line unit. The door will accept a flat or raised panel. The maximum panel thickness where inserted into the door reveal (channel) is 1/4" thick. For raised panels, the depth of the reveal is 1/4" on the sides and bottom, and 1/2" on the top (allow for proper clearance when installing a raised panel). The size of the door panel insert is shown below:

The door panel insert must not weigh more than 20 lb.

17