User’s Manual
Custom Door Panel Dimensions |
|
|
|
|
|
|
|
| B |
|
| ||
|
|
|
|
|
|
|
| ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Model | A | B |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
CLR 60 |
|
|
|
|
|
|
|
|
|
|
| ||
CLR 60SS |
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
SS - Stainless steel units |
|
|
| A |
| ||||||||
Install the insert as follows:
! WARNING !
Insert edges may be SHARP!
Use care when installing.
1.Remove top hinge screw pin (large Phillips head, see Figure 23). Hold door to keep it from falling.
2.Remove door, being careful not to scratch top of door on
hinge.
3.Remove two small screws holding door handle. Slightly separate door handle from door (see Figure 24).
4.Pull door gasket out of groove (top edge of door only). Start in the middle and pull outwards, moving towards the edge (see Figure 25). This may take some force.
5.Pull handle up and off.
6.Slide custom door panel insert into 1/4 inch channel in door front.
UL131
Figure 23
UL132
Figure 24
18 