www.ultramagicard.com
AVALON and AVALON DUO Printer USER MANUAL
Page 7 of 31
1. Open the top cover by pushing down on it and operating the release catch on the top of the printer.
2. Remove the used dye-film by gently pulling both spools upwards until disengaged from the clips. Take care not to bend and
break the clips.
3. Open a new roll of dye-film.
4. Place the loaded spool into the rear clips and press it into place. The orientation is
correct when the barcode on the end of the spool is on the left. Rotate the dye film roll
to allow the core to lock into position.
5. Place the empty take up spool into the front clips, and adjust the film tension so that
the film is lying flat and straight between the two spools.
6. Gently close the top cover until it clicks into the closed position. The printer will
automatically recognize the type of film that has been loaded and move it to the
correct printing position.
Your
Printer
Ø
Full colour cards
or monochrome Ribbon
Choice
Cards
Per
ribbon
Ribbon
Panel
layout Part Number
Full Colour LC1 350 one side only YMCKO M9005-751
Full Colour AV1 250 one side only YMCKO M9006-566
Monchrome:
Black
Red
Blue
Green
Gold
Silver
White
LC3 1000 one side only K
M9005-753
M9005-753-1
M9005-753-2
M9005-753-3
M9005-753-5
M9005-753-6
M9005-753-7
Magicard
Avalon
Black & Overcoat LC6 600 one side only KO M9005-756
Colour front & Black back LC8 300 front & back YMCKOK M9005-758
Magicard
Avalon
Duo
Colour front & color back LC1 175 Front & Back YMCKO M9005-751
Ribbon Panel Layout Key: Y=yellow, M=magenta, C=cyan, K=resin, O=overcoat (No Color)
• AV1 dye-film is the appropriate choice for colour printing
• LC1 dye-film can also be used for colour printing.
• LC8 dye-film, for the Tango 2 models only, is more economic when printing in colour on one side and
black on the other.
• LC6/LC3 dye-film - where cost is critical, monochrome printing is a fraction of the cost of colour printing.
The table below is a
g
uide to selectin
g
the best d
y
e-film to use for an
y
intended a
pp
lication.