1.Turn OFF the power to your computer and any other connected peripheral devices.
2.Unplug the power cord from the back of the computer.
3.Remove your computer’s cover.
4.Remove the slot bracket from an available PCI slot.
5.To install the card, carefully align the card's bus connector with the selected PCI slot on the motherboard. Push the board down firmly, but gently, until it is well seated.
6.Replace the slot bracket's holding screw to secure the card.
Device Connection
The UltraATA 133 PCI is a dual channel Ultra ATA/133 controller that supports up to four IDE hard disk drives or ATAPI devices. If you plan to use the second IDE channel (IDE2).
In order to achieve
1.Install hard disk drive(s) in chassis.
2.Attach one connector on the long end of the Ultra ATA ribbon cable to the board's IDE connector and the other connector(s) to your IDE drive(s). Make sure pin 1 on the cable (indicated by the colored stripe) matches pin 1 on the board's IDE connector and your IDE drive(s).
3.When two drives are installed on the same IDE channel, make sure one drive is set up as Master and the other as Slave. This rule applies to both IDE channels.
3
