To Verify Windows NT 4.0 Installation
1.Double click My Computer/Control Panel/SCSI Adapters.
2.Highlight Silicon Image SiI 0680 ATA/133 Controller from SCSI Adapters listing and click Properties. A message This device is working properly is displayed in the dialog box, the driver has been correctly installed.
Windows 2000
For New Windows 2000 Installation
1.Install the board and follow Microsoft procedures to install Windows 2000 accordingly.
2.Restart your system when prompted during Windows' installation.
3.At the Windows 2000 Setup screen, press F6 to install the driver.
4.Insert the driver diskette. Press S, then press Enter.
5.Select Silicon Image SiI 0680 ATA/133 Controller and press Enter.
6.Press Enter to continue and follow
For Existing Windows 2000 Installation
1.Install the board and boot up Windows 2000.
2.At the Found New Hardware Wizard, click Next.
3.Select Search for a suitable driver for my device (recommended) and click Next.
4.Insert the driver diskette, check Floppy disk drives, uncheck the other boxes, and click Next. Click Next again to continue.
5.Click Finish, remove the driver diskette and restart Windows to complete driver installation.
8
