7
3. Highlight Silicon Image SiI 0680 ATA/133
Controller and click Properties. A message This
device is working properly is displayed in the dialog
box, the driver has been correctly installed. If any
error message is displayed, remove Silicon Image
SiI 0680 ATA/133 Controller and restart your system.
Windows NT 4.0
For New Windows NT 4.0 Installation
1. Install the board and follow Microsoft procedures to
install Windows NT 4.0 accordingly.
2. At the Windows NT Setup screen, press F6 to
specify and add the driver.
3. Press S, select Other, then press Enter.
4. Insert the driver diskette and press Enter.
5. Select Silicon Image SiI 0680 ATA/133 Controller
and press Enter.
6. Press Enter to continue and follow on-screen
instructions to complete Windows NT 4.0
installation.
For Existing Windows NT 4.0 Installation
1. Install the board and boot up Windows NT 4.0.
2. Double click My Computer/Control Panel/SCSI
Adapters, then click the Drivers tab.
3. Click Add… then Have Disk....
4. Insert the driver diskette, type in A:, then click OK.
5. Highlight Silicon Image SiI 0680 ATA/133
Controller and click OK.
6. Click OK, remove the driver diskette and restart NT
to complete driver installation.