Installing Converters into Chassis
Follow the steps below to install modular converters into the 10 space Converter Chassis (pn:
A.Remove the blank bracket from the chassis by rotating screw counterclockwise. Put the blank bracket aside.
B.Open the rack mount bracket kit. The kit contains two rack mount brackets and four screws.
C.Use a screwdriver to attach the rack mount ears to both sides of the modular converter.
10/100/1000T SPD
Auto MDI/MDIX
D.Install the modular converter by inserting it into the chassis guides and sliding it in until it stops. Press it firmly to seat the chassis power plug into the modular converter receptacle.
E. Gently push the thumbscrews in and turn clockwise to tighten.
Do not over tighten.
Hardware Description
The Front Panel
The Front Panel of the 10/100/1000T to 1000SX/LX converters consists of one
10/100/1000T | SPD | PWR |
1 | 2 | 3 |
ON |
|
|
LK/ACT
Auto MDI/MDIX |
|
| FDX/COL |
|
| |
| 550m |
|
|
| ||
|
|
|
| |||
10/100/1000T | SPD | PWR |
1 | 2 | 3 |
ON |
|
|
LK/ACT |
Auto MDI/MDIX |
| FDX/COL |
| Single Mode |
|
| |||
10km |
|
|
Ports
•Copper Port:
•Fiber Port: This port is for the
The Rear Panel
DC IN
The rear panel contains a power socket. This power socket accepts DC9V voltage and minimum 0.7A supplied current.
7 | 4 |