BASIC OPERATION
RECORDING INCOMING MESSAGES
OPERATION | The maximum incoming message recording length is 60 seconds. | |
| ||
| When a recording reaches 55 seconds, the DTAM beeps once to | |
| notify the caller that time will soon be up. When the recording | |
BASIC | reaches 60 seconds, the DTAM sounds one long and four short | |
beeps, and plays "Thank you for your call", then hangs up. | ||
|
The DTAM hangs up and resets to answer the next call when:
•The caller hangs up.
•The maximum message length (60 seconds) is reached.
•There are more than 8 seconds of silence.
If the DTAM’s memory is full (
appears), it will answer the call after 3 rings then play the announcement only message (OGM2).
If no OGM2 is recorded, the DTAM announces "Memory is full, thank you for your call". Please delete some messages to restore normal operation.
SCREENING CALLS
To screen calls, let the DTAM answer them, then listen to the caller’s message through the DTAM’ speaker. If you decide to
answer the call, pick up the phone and press 
on the DTAM.
If you do not want to take the call, do not pick up the phone, and let the DTAM finish recording the caller’s message.
BASIC OPERATION
ADJUSTING THE VOLUME
Adjust volume slider, on the right side of the DTAM to the desired listening level.
PLAYING MESSAGES
The display shows the total number of messages. If there are new messages, the message light also flashes until all new messages have been played.
To play all the messages (old and new), press 
. The DTAM announces the number of messages recorded, each
message number and the day and time the message was recorded and then plays the message.
PLAYING NEW MESSAGES ONLY To play only new messages, hold
down 
for 2 seconds.
(If there are no new messages stored, the DTAM says "You have no new messages").
Adjust the volume to your desired listening level. After all messages have played, the DTAM says, "End of message(s)" and saves all the messages.
BASIC OPERATION
26 | 27 |
