Troubleshooting, Care and Maintenance

TROUBLESHOOTING

TROUBLESHOOTING	PROBLEM	SUGGESTION

	Clock loses time.	• The power to the base unit has been
	Cannot access remote call-in features from	• Make sure you’re using the correct PIN
	another touch-tone phone.	number.
		• Make sure that the touch-tone phone
		you’re using can transmit the tone for at
		least two seconds. If it cannot, you may
		have to change to another phone.

		interrupted. Reset the clock as detailed
		on page (19) of this owners manual.

	Message counter LED flashes	• Follow the instructions on page (16).
	(Battery low or not fitted)	Be sure to leave the AC Adaptor connected
		so you do not loose the stored information.

	Answering system switches on after 9 rings,	• The unit is waiting for your PIN number so
	beeps once, then disconnects after 8 seconds	you can clear message from a remote
		location. Refer to page 33 for more details.

	RESETTING THE DTAM
	If all of the above suggestions do not resolve
	your problem, use a straightened paper
	clip to press RESET on the back of
	the DTAM to reset the answering
	machine.

NOTE:	Resetting the DTAM erases your outgoing messages and all stored

	information.

Disconnect the telephone line cord before operating the

RESET switch.

2.Clean your unit with a damp(never wet) cloth. Solvent or detergent should never be used as they may damage the finish of the plastic casing.

3.Make sure there is space above and to the rear of your unit to allow for proper ventilation.

4.Make sure you check your 9V DC battery at regular intervals for leakage. Replace when necessary.

CARE AND MAINTENANCE