REMOTE OPERATION

CHANGING THE REMOTE OPERATION SECURITY CODE The remote operation security code is preset to 798, but you can change it by following these steps.

1.Hold down code set until the DTAM beeps once. appears.

2.Press again. (security code) and the digits of the current code appear in sequence, then the first digit reappears. For example, when the security code is 798, the display shows

OPERATION

 

(security code)

,

,

, then

reappears.

 

 

 

3.

Repeatedly press

or

 

to set the first digit, then

 

 

press

. The second digit appears.

 

REMOTE

4.

Press

or

to set the second digit, then press

5.

Press

or

to set the third digit, then press

 

 

The third digit appears.

 

 

 

 

The DTAM sounds a long beep and announces the security code.

NOTE:

Be sure to set each digit within 8 seconds. Otherwise, you must start

 

 

over from Step 1.

REMOTE OPERATION

USING REMOTE COMMANDS

To use the remote commands, you must enter the remote oper- ation security code within 8 seconds after the DTAM answers the call. After the DTAM beeps once to verify you entered the code correctly, enter the number(s) for the function(s) you want the DTAM to perform.

Press

To

00

Turn the DTAM off. The DTAM beeps and announces "Answer Off".

01Turn the DTAM on. The DTAM beeps and announces "Answer on" then plays OGM1. If no OGM1 is recorded, the DTAM beeps and announces "You have no announcement one".

02Set the DTAM to answer with OGM2 announcement. The DTAM beeps and announces "Announce only", then plays OGM2. If no OGM2 is recorded, the DTAM beeps and announces "You have no announcement two".

2Play all messages. If no message is recorded, the DTAM says "You have no messages".

3Play new messages. When new messages are recorded, the DTAM announces the number of new messages before playback. If no new message is recorded, the DTAM says, "You have no new messages".

4Monitor the room where the DTAM is installed. The room is monitored for 20 seconds. Press 4 again for another 20 seconds. You can repeat this for as long as you like.

51Delete all messages (except new messages). Press 1 after the DTAM announce "Erase messages", then the DTAM beeps.

REMOTE OPERATION

34

35

Page 18
Image 18
Uniden 7100A manual Remote Operation, Using Remote Commands