Programming
Before the BC45XLT can receive radio broadcasts, you must program a frequency into at least one channel.
Before scanning, repeat this procedure for each channel you program.
1.Select frequencies from your starter guide.
2. Press 
.
3.Select a channel.
a.Enter the channel number.
b.Then press 
.
– OR –
Press ▲,▼, or 
repeatedly until the channel number appears in the display.
b | a |
4.Enter the frequency.
a.Enter the frequency number.
b.Then press 
.
Note: To clear a mistake while entering the frequency,
press 
twice, and start over.
a |
b |
If the frequency entered is outside the Frequency Range of the scanner, a distinctive beep sounds. (See the Table on page 3 or the Band List on the back of the scanner).
Press 
and go back to Step 4.
10
