Plug the DSL filter into the telephone wall jack and plug your phone’s base into the filter. Make a test call to make sure the noise is gone.
Liquid Damage
Moisture and liquid can damage your cordless phone.
If the exterior housing of the handset or base is exposed to moisture or liquid, wipe off the liquid, and use as normal.
If moisture or liquid is inside the plastic housing (i.e. liquid can be heard in the phone or liquid has entered the handset battery compartment or vent openings on the base), follow these steps:
Handset | Base | ||
1. Remove the battery cover and disconnect | 1. | Disconnect the AC | |
| adapter to cut off | ||
the battery. |
| ||
| the power. | ||
2. Let dry for at least 3 days with the battery |
| ||
2. | Disconnect the | ||
disconnected and the cover off. | |||
| telephone cord. | ||
3. After the handset dries, reconnect the |
| ||
3. | Let dry for at least | ||
battery and replace the cover. Recharge the | |||
battery fully |
| 3 days before | |
| reconnecting. | ||
|
| ||
CAUTION! DO NOT use a microwave oven to speed up the drying process. This will cause permanent damage to the handset, base and the microwave oven.
AC Adapter and Battery Information
•Use only the supplied AC adapters. Be sure to use the proper adapter for the base & any chargers.
•Do not place the power cord where it creates a trip hazard or where it could
become chafed and create a fire or electrical hazard.
•Do not place the unit in direct sunlight or subject it to high temperatures.
•Fully charged, the battery should provide about 10 hours of talk time and about 7
|
| Base/Charger |
AC | Part number | |
adapter | Input voltage | 120V AC, 60 Hz |
| Output voltage | 8V AC @ 300mA |
|
|
|
Battery | Part number |
|
pack | Capacity | 500mAh, 2.4V DC |
23
