Uniden DECT1725+1 Dial mode, Tone Dialling Switch-Over Australia only, Registering a new handset

find handset

Dial mode
You can set your phone to use either Tone or
Pulse dialling. The pre-set setting is TONE
dialling, where you will hear a tone beep each
time you dial a number.
Most modern exchanges and switchboards use
Tone dialling, so you should not need to change
this setting. Only change it if your switchboard
uses Pulse dialling or if you cannot make a call
using Tone dialling.
1	Press	menu/ok	to access the main menu.
2	Press	cid	or	untilmenu/ok			is
					BS SETTINGS
	displayed and press					.
3	Press	cid	or	to select DIAL MODE and
	press	menu/ok	.
4	Press	cid	or	to display either TONE or
	PULSE and press			menu/ok	.

Tone Dialling Switch-Over (Australia only)

If you have set your phone to use Pulse dialing, you can switch temporarily to Tone dialing for the duration of a call:

1 Press end .

2Press and hold *tone . Any digits entered after this long press of *tone will be dialed using tone dialing.

Registering a new handset

Registering a new handset

When you register a new handset to your base, you will be asked to enter the base PIN code. The pre-set PIN code is 0000. If you wish you can change this code, see page 29.

Each handset can only be registered to one base at a time. Before registering, make sure the new handset is fully charged and that you have the base and handset in front of you.

On the handset you want to register:
1	Press	menu/ok	to access the main menu.
2	Press	cid	menu/okor	to select REGISTRATION
	and press			.
3	Press	cid	or	to select your base number.

On your base:

4 Press and hold until you hear the registration tone. You are now in 'subscription mode'.

If the base already has the maximum number of handsets (5) registered to it you will hear the reject tone and you will need to de-register one of the existing handsets before you can register the new handset.

See section below for de-registering handsets.

[27]