•The tone feature only applies when the dial mode is set to pulse.
•This special number can be stored in a memory location. This is referred to as Chain Dialing (see page 22.)
[ 16 ] B A S I C S
Adjusting the Handset Ringer and Earpiece Volume
Handset ringer tone and volume
Press the volume up key or volume down key (labeled as, vol/ring/
and vol/ring/ 
) in standby mode to select one of five ringer tones and volume combinations.
Earpiece volume
Pressing the volume up key or volume down key (labeled as, vol/ring/
and vol/ring/ 
) during a call will change the earpiece volume of the handset. This setting will remain in effect after the telephone call has ended.
When you press the vol/ring/ 
key in Maximum mode or the vol/ring/ 
key in Low mode, an error tone sounds.
Temporarily Mute Ringer
If the handset is off the base, simply press the end key to temporarily mute the incoming ring. The ringer will sound with the next incoming call.
Redial
The redial/pause key redials the last number dialed. The redialed number can be up to 32 digits long.
Tone Dialing Switch-over
Some telephone companies use equipment that requires pulse dialing (sometimes referred to as rotary dialing). If you need to enter tone dialing digits, you can
Initially make your call with the pulse dialing mode. Once your call
connects, press */tone/ 
. Enter the desired number. These digits will be sent as tone dialing. Once the call ends, the tone mode is canceled and pulse dialing mode resumes.
www.uniden.com
