•If you are not sure of your dialing system, make a trial call. If the call connects, leave the setting as is, otherwise set for pulse dialing.
•If your phone system requires pulse dialing and you need to send the DTMF tones for certain situations during a call, you may “switch- over” to tone dialing (refer to “Tone Dialing
4) Use the number keys (0 - 9), #/ 
, */tone/ 
, or delete/channel to enter the
5)Press select. A confirmation tone sounds and the displayed area code is entered.
6)Press end or return the handset to the base unit to complete the setting. The handset returns to the standby mode.
When the area code has already been stored in memory, the stored area code will be displayed. To change it, use the delete/channel and number keys to enter the new area code. Then press select. A confirmation tone sounds.
To complete the setting, press end or return the handset to the base unit.
Choosing the dialing mode
Most phone systems use tone dialing which sends DTMF tones through the phone lines. However, some phone systems still use pulse dialing such as in rural areas. The default setting is tone dialing. Depending on your dialing system, set the mode as follows:
1) When the phone is in the standby mode, press and hold cid/menu. The following screen appears.
2) Press 4 or press the vol/ring/ 
key three times to select “Dial”.
3) Press select to toggle between “Tone” and “Pulse”.
4) Press end or return the handset to the base unit to complete the setting. The handset returns to the standby mode.
Setting the language
1)When the phone is in the standby mode, Press and hold cid/menu. The following screen appears.
2) Press 5 or press the vol/ring/ 
key four times to select “Language”.
3) Press select to toggle between “Eng” and “Fr.”.
4) Press end or return the handset to the base unit to complete the setting. The handset returns to the standby mode.
[ 14 ] G E T T I N G S TA R T E D | www.uniden.com |
