Turn on the answering system remotely

If you have forgotten to turn on your answering system, you can turn it on remotely from any touch-tone telephone.

1)Call your telephone number.

2)Wait ten rings until the system answers. You hear a beep.

3)Press 0 and then enter your PIN code. The answering system announces the current time and the number of messages stored in memory. You hear “To play incoming messages, press zero two. For help, press one zero”.

4)Press 0 then 6 to turn the answering system On. You hear the outgoing message and a confirmation tone.

5)Hang up the phone and subsequent calls will be answered by the system.

Changing the Digital Security Code

The digital security code is an identification code used to connect the handset and the base unit. Normally, setting the code is not necessary. The first time you charge your handset, the security code is automatically set.

In the rare situation that you suspect another cordless telephone is using the same security code, you can change the code.

1)Remove the handset from the base unit. Press and hold the find hs key on the base.

2)While holding the find hs key, place the handset on the base unit, and leave the handset on the base for more than 3 seconds. A new random security code is set.

To protect you against misbilled calls which might result from your phone being activated by other equipment, the phone has AutoSecureTM feature electronically locks your phone when the handset is on the base. Also, the Random CodeTM digital security which automatically selects one of over 262,000 digital security codes for the handset and base.

If the handset battery pack is completely discharged or the battery pack is removed, the digital security code will be lost. If this happens, a new security code is set automatically the next time the battery pack is charged.

INFORMATION

ADDITIONAL

Installing the Beltclip

To attach the beltclip

Insert the beltclip into the holes on each side of the handset. Press down until it clicks.

To remove the beltclip

Pull both sides of the beltclip to release the tabs from the holes.

www.uniden.com

T H E I N T E G R AT E D A N S W E R I N G D E V I C E [ 43 ]

Page 43
Image 43
Uniden EXAI398 manual Changing the Digital Security Code, Installing the Beltclip, Turn on the answering system remotely