![](/images/new-backgrounds/1251656/2516569x1.webp)
For Caller ID to operate you must first subscribe to a Caller ID service from your telephone company.
NOTE
If you subscribe to a Caller ID service, the time and date will be automatically updated when the first CID information is received. You do not need to set it manually.
4
SET UP
Back-up Battery Installation
1.Remove the two screws on the battery compartment cover under the base.
2.Remove the cover and attach the connector to the battery.
3.Position the battery in the compartment and replace the cover and screws.
The battery will keep information without the power adaptor for 6 months. LOW on the screen means the battery is low, you should replace the battery within 7 days.
Connecting Line Cords
Plug one end of the supplied modular cord into the telephone wall jack. Then plug the other end into telephone base line jack.
Caller ID Insert ‘0’ On/Off
On some telephone networks, to correctly display and dial Caller ID telephone numbers, a ’0’ may need to be inserted. When the power is first connected to the FP103 ]CID insert ‘0’ off]is displayed. If it is not displayed, press the reset button, located at the rear of the telephone base. You may select ‘on’ or ‘off’ by pressing the up or down buttons followed by the store button.
New Zealand: Telecom - insert ‘0’ on. | Australia: Insert ‘0’ off. |
Telstra/Saturn - insert ‘0’ off. |
|
Flash Time
After the caller ID insert ‘0’ option is set the screen will display ]FLASH TIME]. Select either 100 or 600 by pressing the up or down buttons, followed by the store button.
New Zealand: 600 | Australia: 100 |
LCD Contrast
1.Press and hold the store button for approximately 2 seconds until the screen displays
]LCD CONTRAST].
2.Press the up or down buttons to adjust the LCD display contrast to the desired viewing level.
3.Press the store button to set and move to the next menu option or press cancel button to save and exit.
Setting Time and Date
1.Press and hold the store button until the screen displays ]LCD CONTRAST].
2.Press the store button again - the screen displays ]SET TIME/DATE].
3.Press the up or down buttons to move the curser. Press the appropriate number to enter
the time and date. Press * (am) or # (pm). HH : MM | MM / DD |
(hours : minutes) | (day : month) |
If you make a mistake, use the up or down buttons to move the cursor and
4.Press the store button to set and move to the next menu option or press cancel to save and exit.
S E T T I M E / D AT E
AM 12:15 | 01:08 |